Oz07

@AnonymousBosch howd it happen again

I've bought a box too. It does seem tighter cell if that makes sense. Someone else here reccomends it too. If you believe what it says on the tin it's the dogs danglies

No idea on plumbing myself. Is there enough play to disconnect the blending valve and find out for certain if that's the problem?

Think back-up manual control from inside could be problematic. Sounds like holes being needed to be drilled through.

No some is held in by a compressible security tape sticking glass to frame other is just rubber gaskets. YouTube would explain better

Think there are pro brick acid guys now, come round at top out before scaff gets dropped and jet wash with a diluted acid and water mix, then water over the top. Think they were charging 250 a plot round here

Last time I checked I was paying around £28 m2 for standard clear units. Price might have changed since then tbf 33 doesn't sound bad. Check if you need glazing tape as most likely the glazing merchants will have in the factory. Usually if beaded externally it has glazing tape, beaded internally rubber gasket. Probably not always the case though.

20 quid max

When were Windows originally fitted roughly do you think...could be k/soft coat glass has a sluggish greenish tint

I would guess they are 2 bits of 4mm float with a 16mm spacer bar. You know regs on where toughened/laminated is needed or not

That's a 4:16:4 unit. 24mm gaffer tape is adding a nats bollock to the widtj

Talk about hard work here you go I've done it for you https://www.windowware.co.uk/original-don-carlos-knife

Depends on colour with pvc I went 15 overall with grey

That's what I did. Im not sure their sales dept is that knowledgeable but you can discuss with the technical side.

Have you looked at a don Carlos yet? Your scraper could be crap

Google don Carlos double glazing

Is there not guidance on poison manufacturers which makes clear? Can't you borrow Jeremy's super trap lol. Seriously though does anyone here worry about rodent damage to airtightness membranes? For such a critical part of the build it is susceptible to damage from them

Don Carlos is your friend

Im tight myself but being new to this system I just went with a one stop shop and accepted that I probably overpaid a little. I'm happy to start shopping around once I grasp a subject but just wanted this to be all supplied by one firm. My 2 pence!

My manifolds needed irons 25mm to 22mm compression for heating 3/4 to 22mm compression for water. You just have to go with whatever is on what you're connecting to

A mole for a sewer connection never heard that. Water supply yes

After so many loads they are supposed to now. I think you could circumvent by using a different company this time.

You want some 6f2 or something around the outside of that beam will be a bit nicer under foot. Did you have to take any drains inside or can you dig in after? Did the beam being on too of ground push up your ffl or did you dig off first?

Just watch you aren't trapping water if beaded both sides. Sure he knows what he's doing

first two about the going rate depending where you are