Pocster

I’m doing 300 centres because i’m Scared ?

You in trouble???

@Onoff can you finish the bloody bathroom first ? ?

Feel happier with these https://www.readyfixuk.co.uk/products/cable-and-pipe-support-systems/cable-and-pipe-fixings/caddy-and-furze-fixings/general-caddy-and-furze-fixings/esg1-easy-snap-grommet-188470

Yeah the steel I have does have pre cut holes presumably for cables . The edges do seem relatively sharp . Would prefer a rubber edge in there

Yeah I was worried about cables ‘moving’ / wearing against the steel

Yep But he’s doing a partition .

Easier to buy some of these ? https://www.buildingmaterials.co.uk/gl2-gyplyner-metal-stud-fixing-bracket-75mm-leg-1-box-100-pieces?ps=Mjk4PTEwOTk=&gclid=EAIaIQobChMI8IXv1PaE4gIVrbvtCh1bmw0bEAQYASABEgL9KfD_BwE#298=1099 I can fix through my membrane- you have special plastic raw plugs with rubber caps to make a water proof hole . Any screw goes inside the plug .

I’ll experiment with what you’ve suggest ! Got to run now ! Literally , Bristol 10k ?

How do I fit to the wall a vertical every 600 ?

Ok , I’ve watched all the videos - seems easy but they usually show partitions . I’m using a system that doesn’t fix to the wall so you have a top and bottom U track . You can slide the vertical steel stud in and screw the top and bottom . But you can only do that from one side ( other side is against the wall ) . Does this matter ? . Be happier a screw each side . This doesn’t seem mentioned in any videos so i’m Guessing it’s not an issue ....

Double sorted !

Yeah done that

Hey humans ! I’m fairly certain we will be going with IQglass - they answer all my stupid questions - so respect to them ! Anyone been to their showroom ? Might make a day/night of it so recommendations on where to stay and eat appreciated!! RK for the front door though ( swoon ! Finger print , electro lock , pivot etc. Etc. ) cheers all !

You wait ! They’ll be sold before you know it ...

And you are going to display them under some walk on glazing yes?

I’ve use foamglass - it worked out about £10 per block !

This is all true ! Is a bit of a learning curve ...

I eat complicated for breakfast . I then spew it up at lunch time ?

Lol Yes , you can still drive on it - so that area would be polythene block paving I’m planning to have a suspended ceiling somehow ...

Possibly end up hanging myself

Don’t go there ! its not ! ( deep breath ) ceiling upwards 100mm reinforced concrete 40mm vac insulation 10mm particle board failed edpm ? 35mm reinforced concrete 20mm screed 10mm monolithic asphalt type stuff 3mm asphalt protective layer to be followed by plastic pedestals 20mm tiles phew !

Actually thinking about it raw plugs might be better as shorter . Ceiling is 100mm thick . I’ll wait for @Onoff to tell me what to do ... ?

Hey all ! Right i’ve Got some of this metal stud work to install in my dungeon . Is it best ( does it matter ? ) to fix to ceiling and slab that I drill and use screw and rawplug or drill and just use concrete screws ?? cheers

Yeah , I might start collecting them ! internorm guys been today ; so will see what he quotes ....