Jump to content

Underfloor Heating

1332 topics in this forum

  1. UFH help 1 2

    By Stevenwithav,
    • 49 replies
    • 5.4k views

  2. What's this all about

    By Timme,
    • 5 replies
    • 1.3k views

  3. UFH controlled by return temperature 1 2

    By LukasV,
    • 25 replies
    • 6k views

  4. New Member Seeking Advice On UFH

    By Paul Ashley,
    • 11 replies
    • 2.2k views

  5. Water flow in Under Floor Heating

    By athlonoc,
    • 15 replies
    • 2.4k views

  6. Willis pumps and pressures

    By Barnboy,
    • 6 replies
    • 1.4k views

  7. Do I need a pump on my manifold

    By ricardo100671,
    • 4 replies
    • 2.3k views

  8. Wet UFH in 250mm insulated reinforced raft

    By Smallholdertoo,
    • 21 replies
    • 3.1k views

  9. Screed or TeckWarm Insulation Boards (upper floor)

    By North Coast Self Builder,
    • 0 replies
    • 1k views

  10. UFH Overlay Boards

    By hendo141,
    • 2 replies
    • 1.3k views

  11. Does the castellated mat act as the barrier

    By Post and beam,
    • 4 replies
    • 1.4k views

  12. Boiler was worked on now Ufh doesn't work

    By Jentailor,   
    • 5 replies
    • 1.4k views

  13. Help!

    By ufhnoob,
    • 2 replies
    • 1.1k views

  14. Ufh solid floor build up

    By Tommyt01,
    • 20 replies
    • 2.8k views

  15. Stapling fit from below spreader plates

    By blankton,
    • 4 replies
    • 1.4k views

  16. Willis heater UFH. Heaters in parallel or series? 1 2

    By Russdl,
    • 36 replies
    • 5.3k views

  17. UFH/screed question

    By Bournbrook ,
    • 5 replies
    • 1.8k views

  18. HELP: Thermostat choice

    By BotusBuild,
    • 23 replies
    • 3.5k views

  19. Short Cycling, any advice? 1 2 3 4

    By Super_Paulie,   
    • 77 replies
    • 12.5k views

  20. Prowarm flame problem

    By Mossymossymossy,
    • 1 reply
    • 1.1k views

  21. 16mm Manifold with some loops running 12mm pipes?

    By low_and_there,
    • 1 reply
    • 1.5k views

  22. ufh actuators flashing and floor not working

    By Jilly,
    • 13 replies
    • 2.2k views

  23. UFH Manifold temp vs Water tank leaving temperature

    By thefoxesmaltings,
    • 7 replies
    • 2.2k views

  24. UFH not working, Return valves stay cold as compared to heat valve at Manifold and rooms always never reach 16 or above degree heat

    By junaid,
    • 11 replies
    • 2.4k views

  25. Sudden temperature increase across heatmiser stats?

    By Andeh,
    • 5 replies
    • 1.7k views
×
×
  • Create New...