Pocster

Coincidentally @PeterW just messaged me privately and said it looked beautiful ??

? It was a bit of a mare to get 19 pipes to all play nicely . Functionality over form .

An excellent point ! . Noggin to be added . So when are you starting my bathroom??

Yeah . Once I’m sure it doesn’t leak will foam the hole and foil tape over it .

Hep2o connectors on . Seems solid enough

Note to self . lag pipes as you go not after they have all been installed .

Do the stainless steel - will look well smart . What’s the cost of that coming in at ?

Fair point . I’ll semi cheat and wrap all the hots together !!

Ok . Individual hot pipes not an issue . But where they all cross is going to be a pain - photo 2 Rather than try and do each hot individually can I cheat a bit here and wrap the whole lot ( hot and cold ) in some foil backed insulation I have lying around - photo 1

Automate while you can ! Qubino or fibaro dimmers . Go on make the leap !!!!

We should form a club !!

Real skulls always look more authentic

I don’t want to ignore the foamed in block - it keeps me awake at night .... ?

That’ll leak tomorrow ?

The 600mm copper stem and back plate arrived today . 600mm is plenty - my only minor concern is I’ll have a non accessible Hep2o to copper fitting in my wall . Should I worry ??? ?

Exactly what I did - just use off cuts to cover timbers face .

Transmission received and understood!

The hot water comes from a uvc .

Really ? Even though the hot pipes enter no cold space ( loft etc ) ????

Probably a stupid question. But should I lag the hot pipes?. No pipes in the entire build go through a cold space i.e. they are all within the insulated build. The hot pipes (due to so many of them) do cross over cold pipes - so not sure if that's an issue. Thanks in advance as usual!

Hey ! Yet to turn mine on ! . Tbh even if I did I have no windows or doors - so unlikely to be effective ?. It’s all coming though ; just slowly .............

Our build is more complex but we had the exact same issue that the ufh clips could not penetrate the below ground water proofing . Just used the ‘egg cup’ plastic ( forgive lack of terminology) . So ufh clipped inbetween those . Upper layer ( which is B and B ) did a membrane first , then pir - then sheet to protect pir from screed . So happily pierced that sheet with ufh clips .

Crumbs ! Makes discussions with the EU look easy . What an earth is going to happen when we get to plumbing , electrics etc. Etc.

I’m sure you are right - it’s just Sod’s law and all that . But using the floor to effectively mark the ceiling is a neat tip !

+1 for bpc