Pocster

Sure thing. I was just checking it's all correct. Tiles not even stuck back on the wall yet....

Right 2nd time ( hopefully ) ??

Assume this is better . Nothing fixed yet . Guessing these geberit pipes go here ?

I know . I remember you saying this in another thread . I do like the smooth non textured finish though . But ‘patching’ it will be a dog unless I respray that tiny area - which I am prepared to do . It’s just the thought of cleaning the sprayer again ....

Waiting for someone to say that !

Nope . That’s why I said 50 quid for a tin in my sprayer . I can probably buy a tester pot and then try your fine roller approach .... Paint was a silk / vinyl ; moisture resistant type thing . The whole point of it being a ‘skin’ is to keep moisture out .

Or just fine mini roller and hope for the best ?

Tempted to pva the edges down . Only a small portion is exposed once I reset the beading . Then mask half the bathroom out . Spend 50 quid on the smallest paint quantity ( same brand obviously ) . Spray it for 10 seconds . Then 3 hours cleaning sprayer ??

It’s like a stretchy ‘plaster ‘ . Actually quite hard to tear . Well ! Apart from the bit I ripped off .

Because I ripped some beading off that had a line of Mastik stuck to the paint .

It doesn’t ‘tear’ its a ‘film’ . The larger bit I got off was surprisingly stretchy . Bathroom type ; moisture resistant paint not like emulsion ...

Fine sand paper removes the plaster bot the paint . Paint is a silk type Adair so like a ‘skin’ on the plaster

So just finely sand the torn paint back to good I.e stuck paint ? Then fine roller ? . I could set the sprayer up just for this bit if I really really have to !! Photo to help place issue

Sand ? . You mean the paint edging ? . Shouldn’t I just stick that down ??

I was so careful had to remove some beading but took the paint off ? This was sprayed on . So what’s the best way to ‘fix’ this - so it looks perfect again. ? Worried if I brush or roller first will look wrong . PVA the edges of the torn paint layer down first ?? grrrrrrr

Don’t know what you’re missing ????

Mistress can be a pain also ...

Such is life . A sequence of errors with the occasional success .

Yeah I was considering lining up the grout lines wall to floor . I was more worried if 2mm wasn’t wide enough I.e grout would fail - but it would seem with modern products it’s ok .

Dirty bastards !

Mapei also say 2mm ok with their product . Guess I’d need not worry ?

Though BAL do suggest 2mm grout line is fine with their product ...

Reading online it suggests 3mm min grout width for floors . Watched the rubi delta levelling system ( which I used on my walls with 2mm spacers ) - in the vid the floors done with the white clips - which are only 1mm . So I’m asking am I ok with 2mm for the floor ??? .

Alcatraz ?