Joist hangers not great.

[John2000]

Hello, the builder here has gone a bit well… I dnlont know without being rude. 

He’s done a really good job throughout but let down on these bits which are the joist hangers. One is a car crash which he said he let his labourer loose and is going to change. The other 3 are partially nailed. (One folded down at top but on a double for stair opening. The others on a single but just down one side or holes omitted. My BCO suggested extra nailing from joist direct to ledger but really should I be getting him to cut off bolts and  re fit where I can? (The car crash one he will) the one with hanger bent down at top could be enhanced nailed direct into ledger? - although it’s on a double for stairs. The one that is only down one side is also not great but only on a single, as his the partially, they’re both nailed in top though so I thought the one jumping the patted plate is ok. The half side only - I don’t know. Any practical suggestions please fixed please? 

[ProDave]

Pictures?

 

Doesn't building regs say to nail in every hole?

[John2000]

28 minutes ago, ProDave said:

Pictures?

 

Doesn't building regs say to nail in every hole?

 

[John2000]

Theirs a nailing schedule on the hanger. I.e 20 for face fix only. 8 for face and 4 top. The schedule doesn’t give a mix though although their are others ways around apparently without hangers but needed to know the best alternatives 

[Russell griffiths]

The car crash one is an important one as it’s a double joist. 
get him to install a bolt in the wall in the right bloody location 🤦🏻‍♂️

then sink the nuts in on the wonky ones so they are flush, then re fit the joist hangers correctly 

Fark me it’s not that hard. 
 

why are the bolts at a stupid angle. 

[John2000]

I assume he let the labourer loose. I wasn’t impressed. He’s back next week to sort them out. I didn’t think about recessing the nuts in. Theirs another that’s nailed one side that’s again (near the pipework) some wierd F’ing situation that could’ve been avoided but it is partially nailed on top though. It’s just annoying and lucky I’m on top of the checks before I dragged BCO out only to fail it. Rest of the work is spot on or even overkill. Doesn’t add up. 3/4 money held back though until sorted. 

[Super_Paulie]

Count yourself lucky. I found this beauty on the entrance to my new upstairs bedroom.

[torre]

9 hours ago, John2000 said:

another that’s nailed one side that’s again (near the pipework)

There's nothing in that last picture to indicate how the ledger board is bolted to the wall at that point. The last fixing could be some distance away on the right leaving that corner poorly supported. Do you have a design showing how this is supposed to be installed? I wonder if the ledger has been cut around the pipework. 

 

22 hours ago, Russell griffiths said:

why are the bolts at a stupid angle. 

I guess this is because they knocked a hole in the wall to install a padstone and the wall next to it wasn't intact enough to fix into.

 

The washers used on those wall bolts don't look that large or substantial to me. If you tighten a bolt with a socket does the bolt and washer pull through into the timber? If so then I don't think it's doing it's job