Solar Thermal From Scrap...AGAIN!

[Onoff]

It's finally happening:

 

 

 

Using unistrut instead of proper channel so had to get creative with some 3D printed spacers:

 

 

 

[Pocster]

9yrs ?

[marshian]

51 minutes ago, Pocster said:

9yrs ?

 

Have you fixed your leak yet ? 😉 

[ToughButterCup]

How do you manage the water flow (piping) through the roof membrane(s) ?

[Onoff]

1 hour ago, ToughButterCup said:

How do you manage the water flow (piping) through the roof membrane(s) ?

 

Something like this probably. I'm not BUYING a proper flashing. Going to wet diamond drill the tile and 3D print flashings. All glued down with CT1.

 

 

 

[Onoff]

Would these corrugated stainless pipes do as the interconnects at the top of the panel between panels 1 and 2 then panel 2 and 3?
 

https://ebay.us/m/hHy3Fm

 

 

Various sizes. I presume I just equally space my panels on the rail and pick the right length /end fitting pipe?

 

Then the pipes through the roof at each end of the array, same stuff or copper?

 

A lad I'm talking to on another forum reckons he's used copper throughout, his system has been up and running 12 years with no issues.

[Bramco]

1 hour ago, Onoff said:

A lad I'm talking to on another forum reckons he's used copper throughout, his system has been up and running 12 years with no issues.

If you use copper, use 10mm, it means there is less heated water in the hot pipe, so the heat gets to the coil in the tank quicker. we did this in a previous house and afaik, it's still running after 15 years...  😄

[SteamyTea]

Just make sure all the joints are compression ones. 

I think those stainless, corrugated, pipes are to allow for expansion and movement.

Make the system a drain back one and those problems go away, but gives you other problems.