Pocster

The white bath arrived . Noticed a crack on it . Today it was collected . As he loads it on the van he says “ Bit small for you isn’t it ? “ ? . I’m a fat (expletive deleted) like everyone else now !

So much better than @Onoff ‘s efforts and even the Welsh mandolorian aka @Nickfromwales ???

As a LL since brexit tenants from EU dropped right off . Tenants from rest of the world gone right up . This is the biggest brexit ‘lie’ in my opinion . You want to lower immigration? So vote leave EU - and yet in reality you just ‘shift’ from eu migrant to ‘rest of world migrant ‘ . Complete and utter BS ! “ keep those bloody EU foreigners out “ - yeah ; swapped for everywhere else on Earth . A complete farce .

Did she ? . She done a few bathrooms ? ?

Is this hatch going to take longer to install than your bathroom ? ?

Houston we have a problem ! ?

Now I am happy !

Access ? Dirty (expletive deleted)er - no wonder you couldn’t speak !

Speak then ffs ?

Not being funny , and I can’t see it’s been mentioned but perhaps the rads need bleeding ???

Hope you have 24 hours notice to the tenants ?

I thought as advised by the welsh wizard just tile adhesive under the tray ......

Needs to see a shrink . Windows on macs ffs ! ?

Dewalt XR battery anything less is just shame full . Most Android users / abusers go for makita because they like/have simple tools .

I would always expect ‘tiles’ as skirting in a bathroom / ensuite . Just seems better to me ; assuming the floor is tiled of course .

I decided to get my mate Mandy to take a look at my before and after work . He turned to me and simply said “ This is the way “

I know . So f eckibg use it ?

Trims going to save me . Bits that were ok - I think are not now . Until they are trimmed out ! ?

Sorry waste point ( green x ) not clear Dremel marks the spot !!

Bath arrived damaged ! ? But can plan the waste . Was going to use this Y bend off the sink waste - but I can’t cut the pipe low enough to get it in - so just a tee ? Then run up under the timber supports - up just before the screed . Green X on floor marks where bath waste is . Obviously I can’t plan this mm perfect so I need some play . So , standard U trap ? - then a flexi fitting from that ? What fitting goes from that to my solvent welded pipe ? . Presume some compression fitting . I prop the bath up on timbers - do the final compression fitting to solvent weld - then lower bath ? That it ? Links to trap and flexi ( and anything else ) much appreciated.

My winch ? . Did the job ace . Save your back !!

Sounds like pre worded copy n paste response to hope you go away . F that . I hate the piss being taken . Email or written letter best ( send signed for also send another copy with proof of posting ) . They can ignore email . In court proof of posting is sufficient as signed for could be signed by anyone . But in court the more ammo you have the better . I’m in fighting mode ! ??

Yes of course!

Trying to bead the ensuite wall to ceiling gap . Bloody tiles - because not flat ; a dog ! Tried this first bit stuck up with ct1 - foil tape just to hold it in place . If ok tomorrow will still need white Mastik under the upper edge against the wall