Onoff

How about a nice line of evacuated tubes rolled to follow the roof profile then a small steam turbine? I'll get me coat...

Welcome. Some solar gain there! Going to need some shading/ cooling. Sage Glass if deep pockets maybe?

You've got two fridges? ?

One would hope the 6"x6" fence post will fit in the shoe. Sometimes they need a bit of pairing down at the end... IF the 6x6 will fit under your chop saw you can maybe mark a line all round, cut halfway then flip over. You will need some stacked timber a couple of metres away as high as the saw bed is off the ground. This to support the end.

With a DECENT handsaw... I'd mark the cut lines in pencil then with the tip of the saw cut along/into the pencil lines a bit. That'll act as a guide for your saw blade. Apply Mr Sheen to the saw blade.

Go for it. ?

Did well gluing all those little bits together!

So my missus says.... Just been looking for that particular Round The Horne episode...

Nothing worse than an unstable door.

Who knows ref the quality? Might set up tomorrow with a long bit of Cat-5. The Chinglish manual is a treat!

TWO stoned masons now! Welcome.

No one leaves.....

Are you proposing to use 6x3 everywhere instead of 6x2?

Something like this? ?

Seems a lot of work for such a tiny space.....what are you going to do in there? So this, are you positive?

Are you able to go and measure the base of the cabin you're buying?

In the pub / doing a lot of gear most of the time? ? One serious consideration you may want to stop and think about imo is the footprint of the cabin and how it will sit on your base frame. Get it right and water from the cabin sides will simply miss the base frame. Get it wrong and water will sit on the base frame/against the cabin and potentially lead to rot.

I've never seen anything like it it my life...

?

Pushed the button and bought the one in my original link. Might get an additional screen...£65.

Two Welsh bathroom experts now is it? Oh Oh woah I just know that something good is going to happen... Erm...I mean welcome.

Thanks for looking but no, your linked one isn't wifi enabled so no smartphone access.

Look at My sincere apologies. At first glance I thought D was under the corner of the extended deck rather than one corner of the cabin. Small phone/bad eyesight here! I meant buy the shoes, check the hole size then get the studs. Until it's in your hand you don't know 100% what size the holes are going to be. (If they had been 12mm holes maybe you could have used 10mm studs)⁸. What you have will work. Use the 10mm drill bit to drill thru the 10mm holes in the shoe and mark the concrete. Then drill 10mm holes in the concrete. Then fit 8mm studs with resin. Why have you got to send the shoe back? Take a pic, send to the seller saying it's no good, how it's holding the job up and can they send a replacement asap. But don't get snotty.

You've just posted a drawing where on the plan the 4 points make a square. On the 3D sketch they don't.

I told you buy the shoes first didn't I? M8s will be fine in the 10mm holes. Pi$$ easy to drill. Mark, centre punch, 3mm pilot hole then work up say 6mm then 11mm drill.