GEO-PAR Posted August 2 Posted August 2 Hi guys, Any recommendations on the best type of flat roof to go for? Everyone I speak to has a different opinion so I'm sure it will be no different asking the question on here, but still keen to get people's view and reasons why. The roof construction will be concrete hollowcore planks, screed to falls on top, circa 200mm insulation, roof waterproofing (no idea what's best?), pedestals, paving stones. I've been looking at the Bauder total bitumen warm flat roof system, but some other people have said EDPM will be better. One person suggested GRP on the basis it's covered and the sun won't get to it so easily (I know they expand and contract quite considerably). Any thoughts, ideas, etc welcome!
Mike Posted August 2 Posted August 2 49 minutes ago, GEO-PAR said: Bauder total bitumen warm flat roof system, but some other people have said EDPM will be better. One person suggested GRP All can be good or bad - it depends on how well they are installed. I know one high-spec 3-layer flat roof that's still good after 30+ years, and a GRP roof that had to be replaced after 5, so choose your installer with care. Personally I'd choose mastic asphalt. It has a very long history, will last for decades, is readily repaired, with good green credentials too.
SteeVeeDee Posted August 2 Posted August 2 (edited) There are two types of roof: pitched or leaking. Epdm is good as long as its not going to walked upon. It can be repaired but the patches look like a teenager's bike tyre after a while. Ideally its for dormer roofs out of sight, or below roof terrace decks where its covered by a walking surface system. Felt is the industry standard because it's got a predictable life span, it's cheap, companies are always available locally, it's easily repaired, and there are a wide variety of liquid compounds to prolong it's lifespan if necessary. GRP isn't very good and lasts far less than advertised. Its far too brittle for the task it's given. Fixing it to the substrate doesn't make any sense, particularly when one side is exposed to extremes of weather and the other is fixed down. Differential movement is an actual thing and shouldn't be ignored. Its also horribly toxic and cannot be recycled. Edited August 2 by SteeVeeDee Bad spelling and grammar. 1
Nick Laslett Posted August 2 Posted August 2 Other members thoughts on different options from a few years back. 1
Nickfromwales Posted August 2 Posted August 2 Whatever the choice, as there’s dynamic loads from this being a terrace, I’d put 2 layers of decking board under the covering of choice, joints staggered, for bent & braces. Screwed and glued together and NOT nailed. I’d also buy some pedestals with the biggest possible bases, to spread to point load as much as possible.
SteamyTea Posted August 2 Posted August 2 2 hours ago, SteeVeeDee said: GRP isn't very good and lasts far less than advertised I beg to differ. There is still GRP cladding walkways, and roofs I worked on over 40 years ago that are still good. But note I said 2 hours ago, SteamyTea said: Properly done GRP
SteeVeeDee Posted August 2 Posted August 2 1 hour ago, SteamyTea said: I beg to differ. There is still GRP cladding walkways, and roofs I worked on over 40 years ago that are still good. But note I said There are always exceptions to the rule.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now