Pocster

Actually thinking about it more . Where can ( must ? ) the air vent in the property be relative to the log burner ? Can I literally stick a ceiling vent in above the log burner ? ( next to the flu ) ?

Thanks Floor makeup can’t be altered ( ufh etc . ) I could run a pipe from the wall/ceiling below ground to upstairs ( timber frame ) then go to the outside with a vent .

So my flu installer is coming next week . He wants an air brick in the underground section where the log burner is to go . Going to be tricky to install underground !! - can I pipe to it ? I.e air brick above ground but pipe work to below ground ? Also isn’t this just a draft maker ? - I could block it up for the air test at the end . I guess I’m asking if you can get an air brick that’s one way ? ? ; draws air in but doesn’t let it out . Assume mvhr isn’t any help/ relevant to air flow in this situation?!? ?

@Onoff gets brownie points though ?

My filthy joke was lost ...

Sure I’ve had a pint in there

Already fixed those sides . Don’t want the end of the plasterboard hanging on thin air . Funnily enough timber just turned up .

Yeah 600mm centres . Seems rather wide to me . Might still do a noggin every 300mm across them all for peace of mind .

Don’t like these ceiling edges . Ceiling plasterboard would sit on nothing - shove some timber in there . Also assume I need to put noggins in the ceiling at 300mm apart for plasterboard.

Sorting out those awkward angled ceiling bits . Not much fun . They are at approximately the same angle now !! OSB’d them for extra strength .

That was such a crap joke even I missed it !! ??

Din rail is fanless .....

Yeah it’s not the most exciting video - but I was happy . Not strictly ‘ The bridge’ - but will interface to it later . More goodies tomorrow!!

Electronic lock tested ! Nearly wet my pants with excitement!! IMG_1290.MOV

You’re from Cornwall way aren’t you ? No vision - pasties and fudge that’s all ?

Phrased perfectly!

Yes

Yes via phone or iPad wall mounted in bathroom or indeed off other ‘inputs’ ...

Decided some fun today ! Poe router fans all replaced ( still noisy but better ) . Mac with Z wave stick . One Qubino din rail dimmer installed ( by electrician! ) linked to one bath room led ceiling light , triggered by aeotec sensor 6 I.e movement put lights on with timer . I’ll periodically update this thread as I add new goodies !

Ordered ! i feel brave today !

Possible match ? https://www.ebay.co.uk/itm/301997023261

Tenant sent me these photo's. I can't get to the site - hard to tell what I need to order to replace these. One of you guys will know for sure!! Appreciated!

Decided to get the rather meaty 5 core cable through for rgbw led ( better than @Onoff ‘s )

Can’t seem to find my original post ... hmmmm. Apologies if repeating . Screed floor . Marine ply sections about 2 or 3 mm lower . What do I skim on the ply to get it level with the screed ? Just floor tile adhesive ? First to get it all level .

It’s essential you buy your walk on glazing now !