Nice warm weekend ahead. Perfect for fitting insulation between rafters. We need to infill with 200mm of Balytherm.

Before I do so, anyone got any tips?

So far I have been told to 

• cut the sheets with a sharpened trowel or scraper (to avoid dust)
• be sure to 'tie on' while waltzing around on the rafters
• put a couple of temporary battens under the rafters and push the insulation down to them from outside (above)
• foam round the edges of each rafter space, not each sheet (two lots of 100mm)

 

Then there's a BBQ on Monday evening, by when I hope the job will be finished. Everyone welcome.

 

Breaking my new 'never-at-weekends' rule, but his weather is too good to miss. too rare.

Do it from the inside later.

I have one of these bought for the thick stuff:

 

https://www.screwfix.com/p/bahco-insulation-saw-22-560mm-/7498K?

 

But tbh I mainly use one of these. Makes sawdust but deadly accurate:

 

https://www.celotex.co.uk/products/insulation-saw

 

For trimming gun foam I use an old bread knife.

 

 

im with mr punter, at least we always do it after the felt and battens are on, 

carrying big light 8x4 sheets around on a roof just sounds dangerous, even if you are tied on

as for cutting i use this and a stiff hand saw, (I have never got on with the proper insulations saws)

 

https://www.amazon.co.uk/3MTM-Reusable-Full-Face-Medium/dp/B00FYNN6NQ/ref=sr_1_1?ie=UTF8&qid=1525451437&sr=8-1&keywords=3m+full+face+mask

Using up the PIR offcuts recently that have sat in the stable and shed for ages and I've not suffered from the streaming eyes. Maybe it's "de-gassed" over time?

What a horrible job, wear a dust mask! Never again, I’m getting it fitted in the TF factory.

32 minutes ago, Triassic said:

What a horrible job,

Its the absolute pits man, i will be so glad when i am done with this stuff..... if i could have foreseen how horrid using this stuff was before i got commited i would have definatly gone another way. I always wear a propper PPE but its still hell.