Pocster

This explains why you’re such a lazy (expletive deleted) now

Get away from my house !

Stalker !!!

Yes they are very contemporary- so if not your thing I understand .

Hi Try RK doors cheers

Preliminary test of ensuite shower seems good . Just the shower waste to connect up

These are the way to go . Also look at their ‘frame’ systems . Will undoubtedly cost more but makes the job easier

Yes !!! Do this !!

Just buy one of those mu'vers. Can sell it on later like my walk on glass.

Because many a fella has raised your blouse ?

When looking up a skirt you don’t care about the material As they say

Drone on another world ! Bollocks ; this is where the limit of human knowledge and ability strive

I knew you’d like that . Bring back memories does it of the fun in your shower ?

WHO’s A BAD MO FO NOW ! ????

I won’t swear . I will just neatly use piss colour silicone around the edges . Will further in from the edges silicone as @Nickfromwales says - apart from the bottom

I think the technical term here is “ a c@&t of a job “ Used marine ply 12mm . Used one piece for the 2 top fittings . Got 1 decent screw in but the ply had slipped . Decided to cheat and use dry wall screw as couldn’t see the hole in the ply and didn’t want to split it with a normal screw. Done 1 of the lower ones . Got the other to do - but it feels stable already . Slightly on the p*as as the valve wanted to go where it wanted to go . Slight visible over cut on tile ( knew that would happen ! ) . But can push the plate long and was going to silicone the edges as gaps due to those bloody textured tiles .

Ever played ? I just have ! . Couldn’t get the dremel in there so resorted to angle grinder ! @PeterW you were right . The screws were cack ! . All taken out slowly by hand ! I can just about gain 20mm ! Now it’s a case of nano operation to get the Packer in there ... ?

Roper Rhodes don’t do an extension kit but a 3rd party one may fit ? Regarding ‘spinning’ chrome square . O ring does go on the back to hold it . He had no idea why it spins . I can’t see why it wouldn’t ! . Anyway bit of silicone will fix that .

Lucky boy

Just won’t ?

D ucking can !

Not sure . How do I extend the brass bit though ?

I did think that . If it was copper I’d be f’d

I did actually allow for it . I allowed 10mm for tile ; 5mm for adhesive . Checked this when it wasn’t tiled and backer board was on . What I didn’t allow for was tile adhesive is more than 5mm also the square collar is around 5mm . So a bit of ‘drift’ adds up . I was actually more worried about it being too far forward - so I guess over compensated. If I did it again I would deliberately leave this tile out and the backing board . Would be easier to judge and place then . Live and learn

Shouldn’t be cheap screws ( but could be ) I always buy Spax . Already thought to undo screws by hand - didn’t want to risk burring them . Once I can access all 4 - will unscrew them about 10mm or so - should be able to judge it better then .