Anyone mounted a Ubbink UB48 MVHR vent from above?

[Alan Ambrose]

… and made it an airtight seal with the roof. This guy:

 

https://www.ubbink.com/gb/products/building/roof-terminals/pitched-roof-terminals/roof-terminal-insulated-ub48-180mm-black/

 

Best idea we have is to cut the pipe, install in the roof, and then use a SC200 rubber pipe connector to join the stuff above - assuming we can get to it.

[MikeSharp01]

Nope but I am going to - in the near future. So I can perhaps share the journey. Let's hope we can get advice. 

 

In our case we don't yet have the slates on so that I am hopeful that will simplify things.

 

[JohnMo]

Why don't you use ubbink foam duct? Ubbink website states

 

Designed to fit Aerfoam 160 mm & 200 mm, with adaptors available for 150 mm and 180 mm

[Nickfromwales]

3 hours ago, Alan Ambrose said:

… and made it an airtight seal with the roof

Eh? You mean weathertight? 

[Alan Ambrose]

>>> Why don't you use ubbink foam duct?

 

I am, this drops into 180mm foam duct.

 

>>> You mean weathertight? 

 

I am mainly concerned about the airtightness of the ply box that is the roof (that has the foam duct running within) - there’s a membrane and a metal roof to go on top.

 

The main problem is logistical - I’ll take a few pics when I’m up there. Ubbink (who are not good designers imo and have clearly never installed their own products in anger) seem to assume the whole contraption pokes through into an attic where it can be joined to the duct afterwards. (Although how it would be sealed, I can’t imagine.) I have the duct in place and a hole in the right place in the ply and want to install from above. Unlike some Ubbink roof terminals, this one doesn’t seem to be designed to be installed sequentially from above. If the cowling could be installed last following the 2nd sleeve that would work. But that’s not how it’s designed.

[JohnMo]

3 minutes ago, Alan Ambrose said:

am, this drops into 180mm foam duct

Use ubbink joints then.

 

5 minutes ago, Alan Ambrose said:

mainly concerned about the airtightness of the ply box that is the roof (that has the foam duct running within)

Suspect the terminal is designed to go through roof from a cold loft that is outside the airtight envelope. If your doing some different you may have chosen the wrong product.