Jump to content
  • entries
    29
  • comments
    139
  • views
    8922

Water coil installation into MVHR

Marvin

Entry posted by Marvin

1535 views

 Share

This is posted during the design and installation phase during the winter 2021/2022.  The cooling side results are not expected to be known until Summer 2022.

 

As the air passes through the water coil it changes temperature depending on the coil water temperature. If the coil is going to be used for heating only it can be used without a condensate trap. However as this is going to be used for cooling as well I have constructed a drain in the bottom.

 

Coil with lid off. Air flow from top of picture to bottom. Drain in bottom side of coil where air would be coldest.

20211110_190039.thumb.jpg.bdd3bb3ea20bb777f53d29094b77b93c.jpg

 

 

 

This is a picture looking down into the bottom side of the coil. I have added water to test that it runs away which it does.

20211116_114133.thumb.jpg.2b372532a8ade3e60b92fa700d51ee8c.jpg

 

Because the coil is on the push side of the system ( inlet to rooms ) the condensate pipe requires a set of bends to form a sort of trap that the air would not escape from but water would.

20211120_092531.thumb.jpg.4870a76e775080bccf9cae8cf27ddc48.jpg

 

The air pressure in my system is very low as an MVHR pushes in and pulls out air in the building at the same time, so quite balanced.

 Share

6 Comments

Recommended Comments

joe90

Looks good to me, I have often thought about making one of these (I used to have a land rover heater matrix but threw it away ?). I was going to use DHW from the tank as this is close to the MVHR and my build is finished so don’t want to alter things too much. Will be interested in your results when up and running.?

Link to comment
Marvin
On 20/11/2021 at 09:33, joe90 said:

Looks good to me, I have often thought about making one of these (I used to have a land rover heater matrix but threw it away ?). I was going to use DHW from the tank as this is close to the MVHR and my build is finished so don’t want to alter things too much. Will be interested in your results when up and running.?

The coils have been positioned as near to the room inlet valves as practical so the heating/cooling from the coil is not effected by the loft temperature too much. 

I expect to get results from the heating side in a week or so. Still messing about in the loft. M

Link to comment
joe90
10 minutes ago, Dave Jones said:

my concern is mould growing in the condensate being then blasted throughout the house.

But @Marvin has shown a picture of his condensate drain below the coils. I would only use mine for heating so as pointed  out no condensate drain required.!

Link to comment
joe90

My understanding is that once the air has passed the coils (cold) the relative humidity is deposited on the coils and drop to the drain within the unit, the air is then drier and no further reason to create more moisture as it enters the room ?. This happens within the MVHR units which is why they have a drip tray and drain (unless enthalpic like I and some others have).

Link to comment

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...