Best practice to extend short cable to external light

[DIYHacker]

Hi all

 

I need to move & replace the existing external light we have. As you can see its mounted to the board with the wire cut short. This light provides pretty useless coverage outdoors so I am going to replace it but would like to mount it on the other corner wall (as visible in 2nd picture) so I need to extend the wires to reach (maybe 20cm). As they will be exposed to the elements, what is the best / safest way to do this?! I will then mount the wire on the board, paint it etc so you don't notice it.. running new cabling is not really an option here.

 

 

[ProDave]

Fit a waterproof external junction box in place of the old light and extend your cable from there.  Most LED outdoor lamps now come with a captive length of flex.

[Conor]

Easiest thing to do is to buy two lights, replace the original, wire up to original supply. Then run a new cable from the replacement light's terminals to the new light on the other corner. 1.5mm cable should be enough.

[Super_Paulie]

What Dave said. IP65 black junction box and extend the cables/connect the new light via Wago is probably what id do.

Edited November 6 by Super_Paulie

[joe90]

To join a cable I would solder the wires, use heat shrink tubes on each wire and also total external and wrap in tape self amalgamating. 

[Pocster]

Or … join cables with this gel box 

 

 

[DIYHacker]

Thanks all for the advice! Managed to get it sorted over the weekend and got it all decorated. Only bit left is to paint the bit of cable black when I sand down the board and repaint it.. Think it all turned out pretty good.