Hello all, just dropping in to say HI!

[a62vw]

Good evening everyone,

 

My name is Vaughn and I live in Sussex. I've joined the group, both as an aspiring home builder (in the future), but also to offer advice, where I can. I specialise is heating controls (and employed by one of the world's largest heating controls manufacturers). I also ran my own plumbing and heating business in the South East for 9 years, installing gas, LPG, and biomass boilers, heat pumps, solar thermal and a little solar PV too. I have particular interest heating controls, and renewable energy sources for domestic properties.

I am active on other social media platforms, mainly Facebook, Twitter and Instagram.

I look forward to participating as and where I can, and learning as well as sharing knowledge within the community.

 

Regards,

 

Vaughn.

 

[Cpd]

Welcome to the forum, I am sure your advice and specific skill set will be another valuable cog  in this growing forum. Thanks for offering your help. 

[a62vw]

2 minutes ago, Cpd said:

Welcome to the forum, I am sure your advice and specific skill set will be another valuable cog  in this growing forum. Thanks for offering your help. 

 

No problem, happy to share the love and the knowledge!

[Big Jimbo]

Welcome fella. I am going to have a few questions for you, so make sure you stick around for a while.

[a62vw]

2 hours ago, Big Jimbo said:

Welcome fella. I am going to have a few questions for you, so make sure you stick around for a while.

Cheers! I'll do my best to answer!

 

[mvincentd]

Welcome.

 

Here's a qickie for ya;  My heatmiser neostat V2, of which I have 6 plus 1 hw version, all reset the time in the event of a momentary power cut.  I believe they should have a memory.  It's exceedingly tedious.  What might be wrong?

 

Also one area that has historically been the subject of much discussion on here is the Sunamp products (just wap that in the search bar).

For me and I think some others a massive barrier to this system lies with the lack of knowledgeable advisers and installers.

There are a number of owners on here with significant acquired experience of them but we're thin on trusted suppliers to specify, install and troubleshoot/maintain them.

I backed out of the system in great part because there seemed only one viable person whom I could contract, and that one wasn't actually viable to me.

So it would be good for you to declare if/what you can bring to the table re Sunamp?

 

Thanks

[ToughButterCup]

13 hours ago, a62vw said:

[...]

I've joined the group, both as an aspiring home builder (in the future), but also to offer advice, where I can

[...]

 

Welcome: and with an offer like that, you are especially welcome.

Ian

[vivienz]

1 hour ago, mvincentd said:

 

Here's a qickie for ya;  My heatmiser neostat V2, of which I have 6 plus 1 hw version, all reset the time in the event of a momentary power cut.  I believe they should have a memory.  It's exceedingly tedious.  What might be wrong?

 

 

I had some electrical installation work done yesterday that involved the power going off a few times but my stats (same as yours because I copied you!) seem fine with the time. I've only just checked it this morning and it's correct. It would have been a couple of hours behind without a memory. Is there a flat internal battery?

[a62vw]

2 hours ago, AnonymousBosch said:

 

Welcome: and with an offer like that, you are especially welcome.

Ian

Thank you!