Search the Community
Showing results for tags 'mdf'.
-
I have a double detached timberframe garage. It is clad externally with breather membrane, battens and larch cladding, roofed with concrete tiles. Inside it is the bare timber frame racked with OSB. It is dry and well ventilated, but depending on the time of year and ambient conditions, have relatively high levels of humidity. Whilst a useable and practical space, it really could do with brightening up. I am therefore thinking of lining the walls. The ceiling / trusses would probably remain open as this space is used for storage. The space doesn't need to be insulated, although if covering the ceiling may be worth doing. The question is what should I use to line the walls. Plasterboard would no doubt be the cheapest, but given its an unheated space, and RH levels at certain times of the year, may not be a good choice (albeit I would be delighted if the collective view was that it would be okay). I then move up to MDF or PLY, but this seriously pushes the cost up. Any thoughts or suggestions?
- 15 replies
-
- plasterboard
- plywood
-
(and 3 more)
Tagged with:
-
I am making my own door casings out of MR MDF as I cannot source my frames due to different widths. SO I am going to use 18mm for the frame with a 12mm plant on to form rebate. I am having shadow gaps around the door casings so no architrave. Has anybody made themselves a jig as I have 15 door casings to put in? I an thinking something along the lines of a 4 x 2 rectangular frame made to smallest door measurement and properly square. I can attach my door casing to the outside (screwed through the rectangular frame into the MDF)and then place in the opening and pack accordingly. If I drill some elongated holes in the 4 x 2 frame where I would fix the casing I can then fix the casing permanently, remove the screws I attached the casing to the rectangular frame and Bob's ur titfer. Has anybody done this as it must be quicker than doing each casing the traditional way? TIA
- 9 replies
-
- door casing
- frame
-
(and 1 more)
Tagged with:
-
Before considering which kitchen to fit, get a good, reputable kitchen firm or free-lance fitter to come and measure up. This will give you an idea for a basic layout, based on the size of your room, and your requirements / needs. That'll help you to stay focused when visiting the various showrooms, and ensure that you get the most out of your chosen kitchen supplier and chosen range of units etc. Ask your questions here, for impartial, free advice to help you make your decisions.