Shower tray, waste rough?

[Super_Paulie]

Shower tray from Victoria Plumbing. Under the waste is dog rough, will the seal be ok on this with enough CT1 on the rubber? Trap is McAlpine.

[Super_Paulie]

Actually it looks like this "alternative" flange that came with the McAlpine might make the underside a non-issue?

[Bonner]

Yes, not an issue. Mine was like that, the waste seals on the top but plumbers put loads of silicone on the underside as well.

[Super_Paulie]

1 minute ago, Bonner said:

Yes, not an issue. Mine was like that, the waste seals on the top but plumbers put loads of silicone on the underside as well.

 

Did you use the alternative seal like in the photo or just the 2 singles can you recall?

[Bonner]

I don’t recognise the top hat seal so pretty sure it was two separate seals

[Super_Paulie]

What's your take on this @Nickfromwales?

 

CT1 on the trap rim, add the seal, then a bolt load of CT1 on the seal to fill in all that irregularity. Then bring that up to the tray and screw the top clamp ring in bringing the 2 together? There's a top seal as well, not sure that's necessary.

 

Or use that "all in one" seal which came with it, described as "an alternative seal" that seems to traverse from top to bottom, essentially 2 seals joined together with a middle section, I'm sure you'd have seen them.

 

The trap is McAlpine low profile.