UFH Commissioning - What Temperatures to use and will the house get Extremely Hot

[ronco101]

Hi All, 

 

We are embarking on a self-build and the ASHP was installed yesterday and we are awaiting the commissioning engineer tomorrow to turn on and start heating. 

 

I was a little alarmed by the our ASHP supplier planning to just operate the ASHP at its standard operation rather then operating a thermal cycle. From what I have read on line this is important for the concrete screed performance and any floor finishes installed later. 

 

I spoke with our tile installer and tile adhesive supplier and they have recommended the following regime which is more or less a 14 day cycle that involves, 5 days of gradual heat increase (2-3C per day) , maintain at expected operating temp for a further 4 days, before a 5 day gradual decrease in temperature.

 

My question is with regard to the expected operating temperature, which I presume is the outflow temperature of the ASHP (45 degree), that the underfloor heating pipework's will be supplying to the screed for these 4 days. My understanding is that the thermostats will be overridden temporarily for the commissioning and the slab will be consistently heated with this 45 degree water - am I correct? If this is so then theoretically will the house be extremely warm for a few days as the slab should come close to the 45 degree temperature? 

[JohnMo]

My UFH has never reached 45 degrees, for UFH - it never will.  I just started mine as low a temp as I could, ran for a couple days, increased slowly to about 35 and stopped there.

[ringi]

How long have the screed been down for?

[JohnMo]

55 minutes ago, ringi said:

How long have the screed been down for?

The OP hasn't been on since March so unlikely to answer