James94 Posted May 9, 2023 Share Posted May 9, 2023 Just about to start hanging 5 radiators, done abit of research and noticed these manthorpe radiator guides are not ideal when coming upwards from first floor. Don’t think it’s going to be possible to bend the flow and return to the level at which we need them. Would it be okay to put a 90deg elbow on the flow and return to get us down to the valve height? Looking at these valves, is the push fit compatible with all 10mm pipe? I’ve already purchased smart trvs so ideally need to find this without trv. james Link to comment Share on other sites More sharing options...
Jenki Posted May 9, 2023 Share Posted May 9, 2023 (edited) Depending on the pipe used, you maybe surprised. I'd trail fit the rad and see if the pipe bends easily enough. The least joints the better. IMO a 90 bend may give you more problems . Also try using the left pipe for the right-hand side and visa versa. Edited May 9, 2023 by Jenki More info Link to comment Share on other sites More sharing options...
James94 Posted May 10, 2023 Author Share Posted May 10, 2023 @Jenki The piping used is jg it has some movement but not sure how much pressure it’s going to be applying to the fittings. Are all the push fit connections equal in quality and fit plastic the same? I don’t mind paying a little extra for piece of mind. Thanks for the idea of swapping the pipes over as this might release some pressure on the bends, I’ll see how it looks. Also can’t seem to find any valves without the trv, don’t need them as I have some wunda smart trvs, can you recommend somewhere that sell good quality valves? Regards. James Link to comment Share on other sites More sharing options...
gaz_moose Posted May 10, 2023 Share Posted May 10, 2023 (edited) i was under the impression you shouldn't mix and match push fit systems. which way are the pipes going into the wall box? will it turn 180 degree Edited May 10, 2023 by gaz_moose Link to comment Share on other sites More sharing options...
James94 Posted May 11, 2023 Author Share Posted May 11, 2023 @gaz_moose Thanks for your reply, I’m aware about mixing plastic pipes and fittings but I’m not sure how you decide what radiator push fit connections will fit best to JG pipe or maybe it doesn’t matter? I think it’s flow on the left side and return on the right, not sure if pipes will rotate. Does it Make any difference Which way the water flows through the radiator? Also does it make any difference what type of trv valve I go for, it will be connected to a Wunda smart trv head? Regards. James Link to comment Share on other sites More sharing options...
TonyT Posted May 11, 2023 Share Posted May 11, 2023 The smart trv may have a list of compatible trv bodies that once the original head was removed the smart trv is fitted to. best to check manufacturers instructions. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now