Search the Community
Showing results for tags 'wallplate'.
-
I fitted my own wall plate yesterday - with the help of @DavidFrancis. Whoo hoo! Maybe it's a small thing for you, but to me it's a huge victory (over myself) But (isn't there always one but ) look at this ... the gap.... does it matter? No joist runs over it. Ta....
-
Wallplate fitted, ridge beam fitted (nearly), rafters up, insulation fitted in between. Who's a clever boy then? ? Maybe over-worried about fixing the wall straps through to the concrete, I chased the Durisol back to the concrete and fitted the wall straps direct to it. This is where we are now (looking up from the floor); I need to make good on top of the wall straps. Which ? Foam, Durisol, Sand and Cement? (Can't Avoid.... )
- 10 replies
-
Sometimes you bump into really interesting stuff online..... like this (scroll down to the section headed Wall-Plate) Here's the relevant passage '...In order to make the house air-tight, the wall plates have been installed over a polythene membrane, which is shown tacked down until the construction has proceeded to the point where it can be folded up and over the plywood which will soon cover the ends of the joists. Ultimately it will seal against the plywood decking which will be laid on top of the joists....' (https://edinkist.wordpress.com/diary-of-the-build/) To ensure air-tightness at the wall-plate roof interface, is this method (putting the wall plate on top of a polythene membrane) common? I feel some phone calls coming on.
-
The wall plate on the south face of our build runs across two sections: Durisol and steel. I'm almost clear about how to fix it to the Durisol. But how do we fix it to the top of the RSJ ? Is a simple bit of M14 threaded bar with bolts top and bottom sensible? (Countersunk bolt and bar at the top). Or is this a question the SE needs to answer?
-
I'm about to pour the last bit of concrete before putting in the wall-plate on the piggery. Have a look at this; Once I have poured the last 100mm or so of concrete, (in the holes you see) I will need to fasten the wall-plate to it. Should I run the wall-plate right the way through the gable, or cut the wall-plate flush with the gable and fill that with concrete? The image below should help explain.. I have deliberately not poured concrete into the gable block in line with the wall-plate - just in case your advice is that the wall-plate should run all the way through the gable Maybe it doesn't matter, and both options are reasonable. Just for information, this building isn't subject to Building Regs: it replaces the old piggery which has stood there for about a century or so.