Hep2o reducer manifold support sleeve?

[markocosic]

Do you need a support sleeve (will a support sleeve fit in the end of a hep2o reducer manifold?

 

https://www.screwfix.com/p/hep2o-plastic-push-fit-reducing-2-port-closed-spigot-manifold-22-x-15mm/5243f

 

There blank end of these above.

 

I suspect yes but don't want to try demount it (impossible?) to check only to find that the answer is no.

 

@Nickfromwalesdo you know from memory?

[dpmiller]

pretty sure any of the fittings with a male on them have built-in reinforcement

[Nickfromwales]

24 minutes ago, dpmiller said:

pretty sure any of the fittings with a male on them have built-in reinforcement

+1.

 

3 hours ago, markocosic said:

@Nickfromwalesdo you know from memory?

They're 'beefed up' to just be inserted as is. All good .

[markocosic]

Thank you!

 

Panic over. My blood pressure thanks you both. 🙂

 

It's not my house, therefore didn't want any cockup, and woke up in a bit of a flap about why one pair of manifolds (with inserts) were just a touch further apart than the others (an insert further - oh poop I didn't add the inserts on those)

 

Pipes were all marked up when inserted and depthed. Forgot to do that for manifolds as the depth was obvious right...