Jump to content

Vinnie

Members
  • Posts

    4
  • Joined

  • Last visited

Vinnie's Achievements

New Member

New Member (2/5)

0

Reputation

  1. Thanks JSH. Didnt realise I'd created 2 lol Added a pic of the hw/ch pump, 3way valve and controller in case that helps.
  2. Thanks guys. I was kind of hoping that when the heating brings the boiler on that I could tee off the flow from the boiler, (the ufh pump would run in line with the CH pump), then the return would tee back to the boiler. When say, the HW brings the boiler on alone it will just flow past the tee down to UFH loop as the UFH pump wont be running... Is this bad?? ?
  3. Hi everyone. New to the group and was hoping for some advise. I have a JG underfloor heating system installed under my kitchen and through to a downstairs toilet where the pump and manifold are fitted. In the loft above the toilet run the 25mm flow and return direct from the boiler. Can I tee into these to supply the ufh? I have a cable run in from this (ufh thermostat)to the controller in the airing cupboard which I was hoping to link across the heating switch?? Sorry if this is vague or my terminology is not very good. Any advise appreciated. Thanks in advance
  4. Hi everyone. New to the group and was hoping for some advise. I have a JG underfloor heating system installed under my kitchen and through to a downstairs toilet where the pump and manifold are fitted. In the loft above the toilet run the 25mm flow and return direct from the boiler. Can I tee into these to supply the ufh? I have a cable run in from this (ufh thermostat)to the controller in the airing cupboard which I was hoping to link across the heating switch?? Sorry if this is vague or my terminology is not very good. Any advise appreciated. Thanks in advance
×
×
  • Create New...