Hi, I hope you don't mind me hijacking this thread but I am about to fit some velux windows in some box profile roof sheeting and have been struggling to find any info ref install until I came across this post.
I wonder if you can help/advise, I am building a new workshop and the roof construction is going to be 12mm OSB board over roof timbers, then a layer of breathable felt finished with box profile metal sheets 34/1000 0.7mm thick. I have 3 x older style velux windows to install GGL C02 which came with slate flashing kits. I have been in touch with velux to ask what flashing kits I need for the above mentioned roof sheet and they have advised me to either adapt their EDW kit or using the ZWC trim kit (which I already have as part of the slate flashing kit) and special head trim 606189CO, then manufacture my own flashing on site.
Although having successfuly fiitted a couple of Velux windows about 20 years ago, I am unsure how to manufacture my own flashing. Can I ask did you use an off the shelf flashing kit for the quoted install? If so could you advise which kit you used?
I can pretty much space the velux windows where I like, so I should be able place them to line up with the correct edge of the profiled sheets. Do you think I would be best to get the flat section between the profiles lined up with the edges of the velux? Hopefully I have attached a drawing of the sheet profile...
I hope you can help!
Many thanks, Stuart