Search the Community
Showing results for tags 'end panels'.
-
Dear all, Was going great guns putting our utility units and worktop in until last night. I cut the worktop and slid it in place and found this: The laminate worktop is square edge and if I route a curve on this I'm told the edging tape & adhesive doesn't match it well enough to make a seamless join. I'm pretty sure it would be OK on the edge of this bit though. I'm torn now. 1. Do I just stick some edging tape and accept it looks an awkward junction and then move on to the next job OR 2. Order a new end panel and leave it at 600mm deep (current one is trimmed to 580mm to match the cabinet (560mm deep) + 20mm doors ). Take off the old one and replace it. I would need to do both sides. More £ than option 1. Reinstall cabinet the tall cabinet (RHS of the pic) and accept that the door is 20mm back from the panel edges OR 3. As per 2 but remount the cabinet 20mm off the wall so the door is flush with the panel edges. Washing machine going in next door so unlikely that anyone will really notice that these doors are further out from the wall than any other one. moving the cabinet 20mm off the wall will involve a fiddle since id does need a good brace since the rear panel has to be removed for the fridge. I could fix to the end panel. Hope thats clear. Its times like this that I wished I was in the trade and just knew what to do. Interested in your thoughts. Cheers CC44
- 49 replies
-
- worktop
- end panels
-
(and 2 more)
Tagged with: