Jump to content

Vapour barrier


Pocster

Recommended Posts

18 minutes ago, Mr Punter said:

 

You don't need to do any prep before you tile it and if the screeder is good it is smooth and flat enough to lay any flooring (LVT etc) whereas sometimes you can get little ripples and bubbles with liquid.

 

https://www.ukscreedsltd.co.uk/preparing-liquid-screed-floor-tiling/

He said it would be more level with sand & cement 

  • Like 1
Link to comment
Share on other sites

5 hours ago, pocster said:

Just waiting for foam to go off ; then will cut excess followed by foil tape all joints .

I don’t know ; feels like my build consists solely of pir with some cladding ?

F3FE8350-2D09-4E17-98A9-CFDD4D35954B.jpeg

That picture brings back memories from 2 years ago....  looks like a neat job.  Have you left enough of the dpm to tape your airtight membrane onto?

 

As @Onoff says make sure you pin the ufh pipes down well, our screeders wanted extra to protect against the pipe lifting.

Link to comment
Share on other sites

31 minutes ago, CC45 said:

That picture brings back memories from 2 years ago....  looks like a neat job.  Have you left enough of the dpm to tape your airtight membrane onto?

 

As @Onoff says make sure you pin the ufh pipes down well, our screeders wanted extra to protect against the pipe lifting.

Lol

No dpm ; just vapour barrier to go ontop 

Link to comment
Share on other sites

On 11/04/2019 at 08:28, JSHarris said:

@SteamyTea) did an experiment with samples of EPS to see whether it absorbed water or not

It was with some waterproof MDF and a bit of ply.

The MDF absorbed very little water, less than 1% by mass, the ply not so good, but the adhesive was as good as new.

Link to comment
Share on other sites

  • 1 year later...
On 11/04/2019 at 09:46, Jeremy Harris said:

In our case, we have 200mm of Type 3, blinded with ~50mm of coarse grit, under the EPS, and 100mm land drains around the periphery, under the edge of the ballast, to ensure that it's well drained.  In addition, the base of the EPS is at ground level anyway, the photo below shows the layer of Type 3 before it was blinded and the EPS was laid.  It's really hard to see how water could be pushed upwards into the EPS.

 

In our case it's on 150mm of Type 2, blinded with sharp sand and then EPS (without any DPM between sand and EPS).  This is the same foundation system/manufacturer as Jeremy and many others.

 

We hadn't realised that the detail in our foundation design had this until the slab was in. ?. Agree with @ADLIan that it's not really the way to do things, but I don't know if it's an issue in practice, other than potential for small decrease in u-value due to moisture absorption through capillary action.  Any thoughts?

 

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...