Jump to content

How deep should the top of the footings be below ground level?


Recommended Posts

1 hour ago, brickierob1 said:

Hi everyone, 

I'm wondering the answer to the above question in regards to a rear extension, which is 1200mm deep by 800mm wide. I'm looking for a definitive answer, but I'm unsure there is one. Is their any factors that would contribute to the answer. 

 

Many thanks

I filled our flush 

1800 deep It’s a toss up between 

the extra concrete used and the amount of brickwork and Labour you save 

 

92CE6B2F-1E75-439B-866A-5359B9CFC3BC.jpeg

9D50754A-ED52-48DA-B367-E7E35C2A09E4.jpeg

Edited by nod
Link to comment
Share on other sites

Personally,minimum 450mm from dpc to top of concrete. 
That leaves enough room to get the pipework in with lintols over the voids before you’re coming out of the ground. 
You’d hope with those two bed joints on the blocks that you can get over any discrepancies in the concrete but you’re at the mercy of others commitment to accuracy there. 

Link to comment
Share on other sites

4 hours ago, Russell griffiths said:

Work it out from damp course down, if you have blocks below dpc you don’t want to be cutting them. 

 

+1

 

Remember when your school teacher taught you about "lowest common multiples" in maths ?

 

If building outer leaf in brick and inner leaf in block there is a height at which X number of brick courses is the same height as Y number of block courses. So if you fill the trench to that height below DPC you dont have to cut any bricks or blocks.

 

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...