Onoff Posted September 3, 2019 Share Posted September 3, 2019 Anyone know what the standard size for the o ring is? Measuring one I reckon 7mm internal diameter, 1.5mm section. Cheers Link to comment Share on other sites More sharing options...
Temp Posted September 3, 2019 Share Posted September 3, 2019 I wasn't able to google that info but found whole tails with rings for £3:45 inc delivery from UK seller on eBay. Swap the rings over if not right length? https://www.ebay.co.uk/itm/10mm-x-1-2-BSP-Fitting-Basin-Monobloc-Mixer-Tap-Connector-Flexi-Hose-Pipe-Tails/162644180159?epid=2202974869&hash=item25de593cbf:g:CJwAAOSw~T9aawZt&redirect=mobile Link to comment Share on other sites More sharing options...
MikeSharp01 Posted September 3, 2019 Share Posted September 3, 2019 Take one off and measure it? Link to comment Share on other sites More sharing options...
Onoff Posted September 3, 2019 Author Share Posted September 3, 2019 It's just the o rings I'm after sourcing and 7x1.5 is what I've measured them at. Link to comment Share on other sites More sharing options...
ProDave Posted September 3, 2019 Share Posted September 3, 2019 https://www.ebay.co.uk/itm/Nitrile-7mm-ID-x-1-5mm-C-S-O-Ring-Choose-Quantity-7x1-5-New-Metric/293135773763?hash=item444040f043:m:mZAHIXQV1FNd_PbsrtdbwwA 1 Link to comment Share on other sites More sharing options...
PeterW Posted September 3, 2019 Share Posted September 3, 2019 36 minutes ago, Onoff said: It's just the o rings I'm after sourcing and 7x1.5 is what I've measured them at. When do you need them..?? Got a whole box of different sizes I can send you. 1 Link to comment Share on other sites More sharing options...
Onoff Posted September 3, 2019 Author Share Posted September 3, 2019 14 minutes ago, PeterW said: When do you need them..?? Got a whole box of different sizes I can send you. Thanks. They're for work. It's for inside some posh £500 taps with built in pir. I took my own "big box in but the closest I had was 7×2. I then noticed the tap tail ones looked a fraction smaller on the section at about 1.5mm. I'll just tell them to source a load of 7x1.5mm. Was hoping there was a standard for the tails. Thanks again. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now