Search the Community
Showing results for tags 'pumps'.
-
Hi. I have a new underfloor system which got 4 zones, although they are quite close and not really necessary to split. I wonder how I can control it best via Tado and or Alexa. I would like to turn the underfloor heating off when a max temp reached and/or over night. As I have 4 zones it looks like I would need 4 wired Tado Thermostats, which is crazy. Is there not a way to turn of for example the pump via Tado. or if not can I just turn of the pump with a smart socket using the thermostat temperature via Alexa for example? Thank you in advance for your thoughts
-
Good Evening and Happy New Year My next question for estimation. Once I have listed everything that I think that we need and got my approximate estimate I shall send off, but right now I'm listing everything and pricing it myself, this is what covid does to you when you can't go to the pub. My single storey barn conversion has a flat roof so there will not be any form of header tank, there will be an emersion tank in the utility room. We will have 3 showers for which I need pumps. But, all the ones I look at say 'gravity fed', which sounds to me like they need a higher tank. These pipes will need to be horizontal, one at 2m, one at 12m and one at 25m, all from the DHW tank. It is very rare that multiple showers are used at the same time, but not impossible. I'm not worried about the hot water, we have 2 showers with pumps in the existing house and it has not been an issue waiting for hot water. My issue is that I don't know what type of pump I need. I know one of ours needed replacing recently, at about £200. The existing pumps are on the same level as the showers by the tank, but we do have a cold water header tank and I'm not sure if this makes any difference. Do I need the same as we have now. TIA Jill
-
So the plan is this. 3 or 4 IBCs buried under the patio linked together at the bottom with the first tank connected to the downpipes using filtered hoppers and the supply taken from the last in the line to limit the sediment transferring between them. I then plan to put a 5 micron filter and an activated carbon block in the garage before feeding the WCs, washing machine and outside tap with the supply. Question is - should I use a submersible pump or a jet pump...? Both will need some sort of pressure switch to sense a tap opening or a WC flush, but there the similarity ends. My thoughts are that a submersible pump will be cheaper and easier to maintain but by design it will pick up more sediment and that means the filters will need changing more often. Also, it will cut out at a higher water level. A jet pump will sit the clean side of the filters so will not be prone to pulling as much sediment - plan to pick up from just below the water surface with a floating pickup - but for a pump with a switch and a pressure tank it is much more expensive. Other option is to pick up from the IBC outlets and balance across all 3/4 tanks with the jet pump that slightly reduces the cost as the links will be 25mm MDPE. The commercial models tend to do in tank pumps but that means you don't get the full water capacity. They also need a separate flow / pressure switch but not too worried about that. So has anyone else used anything like this and have any thoughts ..??