Search the Community
Showing results for tags 'inlet'.
It seems to be my week for thicky questions, or certainly naive ones. I've only ever had one dishwasher and this has finally given up after 18 years of service, so I know very little about all their bits and bobs. The new one is coming tomorrow, so we were taking out the old one this evening. Crack, spray, squelch. The plastic part that is on the end of the water inlet hose and between that and the connector that screws into the dishwasher broke and is beyond repair. Is the part that screws into the new dishwasher a standard thing, or do they vary in size from brand to brand? Can I just walk into a plumbing supplier and just buy a new one, or do I need to order from a supplier?
We are going to have a ground floor plant room (1900 wide x 2150 deep) in which we will put the MVHR unit. We are also installing a gas boiler for DHW but I'm not sure where to install it - either in the plant room with the MVHR unit or in the utility room. My concern is around the necessary separation of the MVHR inlet and the flue for the gas boiler. Does anyone know what the regulations state and what is actually required in practise? I have a feeling that any regulation, should one exist, might not be good enough rather than too much!